|
Author |
Message |
EmacD |
This post is not being displayed .
|
EmacD L Plate Warrior
Joined: 26 May 2012 Karma :
|
|
Back to top |
|
You must be logged in to rate posts |
|
|
Casper |
This post is not being displayed .
|
Casper World Chat Champion
Joined: 12 Jul 2010 Karma :
|
Posted: 12:16 - 26 May 2012 Post subject: |
|
|
It also looks the same as the GPz ones. I would say as long as your not going to use a smaller one you should be fine. Try and get the part number from this site
https://www.cmsnl.com/
And look at the part number for the 750 and the gpz550/750 or the zephyr 550/750. You can look at the ZR7 but that may be slightly larger. |
|
Back to top |
|
You must be logged in to rate posts |
|
|
Casper |
This post is not being displayed .
|
Casper World Chat Champion
Joined: 12 Jul 2010 Karma :
|
Posted: 12:18 - 26 May 2012 Post subject: |
|
|
Just had a look at your location. You must be close to Braking point in Aberdeen. Im sure they will sort you out cheap.
https://www.breakingpoint.co.uk/ |
|
Back to top |
|
You must be logged in to rate posts |
|
|
EmacD |
This post is not being displayed .
|
EmacD L Plate Warrior
Joined: 26 May 2012 Karma :
|
Posted: 15:10 - 26 May 2012 Post subject: |
|
|
Thanks for the reply. My experience with breaking point has not been good. I have had them do work on my bike in the past, and it has been less than sterling service! So out of principle I will not had any more money to them!
I have looked at the GPZ and the fitting looks similar, but on the GT750 it looks like the mounting holes are slightly different. the ZR7 would be a good one as well, but requires a bit of customisation to mount.
I have a cooler (in really good condition) from a Honda CB750 in good condition, but it uses Flange mounts rather than JIC type ! ____________________ Thanks |
|
Back to top |
|
You must be logged in to rate posts |
|
|
EmacD |
This post is not being displayed .
|
EmacD L Plate Warrior
Joined: 26 May 2012 Karma :
|
Posted: 15:23 - 26 May 2012 Post subject: |
|
|
The GPZ and the GT have the same part number on the Dutch site, so that opens up my possibilities! (i.e. 39061) ____________________ Thanks |
|
Back to top |
|
You must be logged in to rate posts |
|
|
Old Thread Alert!
The last post was made 11 years, 337 days ago. Instead of replying here, would creating a new thread be more useful? |
|
|
|