Superped 50/70cc ped with 70mph potential £650 ONO

[Iain.]

Currently my only means of transport.

https://i.ebayimg.com/00/s/NTc2WDEwMjQ=/z/8HoAAOSwrklU35rd/$_86.JPG

Used as a tuning project to see what could be had out of a Chinese bike. Has hit 68mph on the clocks, need to run a proper GPS pull again now I've fitted the 21mm carb on it. With standard carb the bike ran 62mph on GPS so the speedometers fairly accurate. The only chinese bits left of the engine are the cases and even those were ported to match the top end. Works out at retail that it's got about £550 of aftermarket bits on the engine

1900 miles on the clock. Engine build was 50miles ago, so it's basicly all new. MOT'd till November.

Leo Vince TT exhaust
HPC race crank
Athena HP 70cc cylinder kit (single ring piston)
Motoforce reed block (carbon reeds)
21mm carb - hours spent setting this up including idle jet.
Pedmoto foam air filter
Stage 6 manual choke kit
Athena main bearings
Athena crank seals
Doppler variator (conversion to 19x15.5 rollers)
Doppper/JMT rollers 3x4.8gr, 3x4gr
Motoforce evolution clutch - red springs fitted, shoes drilled to get later engagement.
Doppler torque spring
Naraku race belt
Naraku race coil
NGK plug (heat range 9)
NGK plug cap
Oil pump removed and blanked, oil pump gear also removed.
Crankcases ported to match cylinder kit.

Runs on premix, I've always used Castrol A747 & that's what it's jetted for. 30ml oil to 1 litre of petrol.

Am open to offers, but nothing silly.

https://i.ebayimg.com/00/s/MTAyNFg1NzY=/z/4UMAAOSwstxU4b7W/$_86.JPG

https://i.ebayimg.com/00/s/NTc2WDEwMjQ=/z/eFkAAOSwPhdU4b7n/$_86.JPG

https://i.ebayimg.com/00/s/NTc2WDEwMjQ=/z/tagAAOSwpDdU4b74/$_86.JPG

https://i.ebayimg.com/00/s/NTc2WDEwMjQ=/z/IGQAAOSwqu9U4b8E/$_86.JPG

https://i.ebayimg.com/00/s/MTAyNFg2NDg=/z/X74AAOSwZjJU4b~k/$_86.JPG