removing crankshaft

[Im-a-Ridah]

I followed like it says in the manual to heat the area around where the bearings are then tap the crankshaft with a hammer, but it doesn't come out. I can't heat the bearings directly, because I cant get to them, any ideas?

It's an RS125 btw

[cagiva gezzer]

Hit harder.
____________________
"because one stroke isnt enough and four strokes waste two"

[Im-a-Ridah]

[Jamie S]

How long did you heat it for and what did you use ? Because by the sounds of it you aint heated it up enough.

[Im-a-Ridah]

[lukamon]

duuuuuuuuuuuuuuuh direct on the shaft?

heating things up EXPANDS THEM silly, no wonder it wont come out try heating up the casings. oh, and if the piston wont come off the wrist pin, heat it up with said heat gun
____________________
killa wrote: Im an ass man myself