Intermittent instrument cluster fault on K2 bandit

[talkToTheHat]

Every now and then I get a fault with my instruemnts, I still have idiot lights and backlights, but either the LCDs will go blank and dials will stick in place for a few minutes or the clock will reset to 1:00 and the dials will do their switch-on routine (all the way round and back to zero)

Is there a common fault that causes this or is this checking the loom for a bad wire?

I assume this is a power fault rather than a signal input gone as the time is resetting?
____________________
Bandit. does. everything.

[talkToTheHat]

Never mind, fixed it. Instrumentation cable was installed incorrectly and had some damaged insulation and internal corrosion.

It's an arse getting the clocks off so I can lift the dash/fairing inner panel. Anyone have a trick for this?
____________________
Bandit. does. everything.