|
Author |
Message |
Suzuki intruder |
This post is not being displayed .
|
Suzuki intruder L Plate Warrior
Joined: 18 Mar 2020 Karma :
|
|
Back to top |
|
You must be logged in to rate posts |
|
|
Easy-X |
This post is not being displayed .
|
Easy-X Super Spammer
Joined: 08 Mar 2019 Karma :
|
Posted: 13:06 - 18 Mar 2020 Post subject: |
|
|
That carb has been copied extensively and re-cast from the finest Chinesium I'd take a peek at Amazon, eBay, Aliexpress, etc. and you'll probably turn up something similar.
If it was me I'd just get something like this:
https://www.ebay.co.uk/itm/For-Suzuki-EN125-Marauder-GN125-GS125-GZ125-Carburetor-Carb-Motor-Engines-26mm/163660393280
And see about swapping the throttle wheel thingy that the dual cables connect to from your original to the new one. Feck all money to have a go
But before that I'd strip it and clean it again. This time check every channel for blockages and get the jets, emulsion tubes etc. under a magnifying glass. Also check the black rubber diaphragm for tears. ____________________ Husqvarna Vitpilen 401, Yamaha XSR700, Honda Rebel, Yamaha DT175, Suzuki SV650 (loan) Fazer 600, Keeway Superlight 125, 50cc turd scooter |
|
Back to top |
|
You must be logged in to rate posts |
|
|
Suzuki intruder |
This post is not being displayed .
|
Suzuki intruder L Plate Warrior
Joined: 18 Mar 2020 Karma :
|
|
Back to top |
|
You must be logged in to rate posts |
|
|
Easy-X |
This post is not being displayed .
|
Easy-X Super Spammer
Joined: 08 Mar 2019 Karma :
|
|
Back to top |
|
You must be logged in to rate posts |
|
|
Suzuki intruder |
This post is not being displayed .
|
Suzuki intruder L Plate Warrior
Joined: 18 Mar 2020 Karma :
|
|
Back to top |
|
You must be logged in to rate posts |
|
|
Bhud |
This post is not being displayed .
|
Bhud World Chat Champion
Joined: 11 Oct 2018 Karma :
|
|
Back to top |
|
You must be logged in to rate posts |
|
|
nathlx |
This post is not being displayed .
|
nathlx L Plate Warrior
Joined: 18 Jul 2020 Karma :
|
Posted: 22:24 - 18 Jul 2020 Post subject: |
|
|
Any update on how this went? I am in exactly the same situation, got a (free) suzuki intruder 125, only problem its been sat for 12 years outside.
It almost ran after some cleaning but I stripped the carb and found the choke has siezed into the carb body, and the float slide doesn't move up and down anymore, I think I need a new carb but I cannot find one anywhere except an old one on ebay for 190quid!
I found that the v-star 250 also uses the mikuni bds26 but without the TPS, and with accelerator cable connection on the other side, the chinese imports look good but as you said, all have no TPS!
Is no TPS a dealbreaker? Anyone got a UK source on a vl125 carb? |
|
Back to top |
|
You must be logged in to rate posts |
|
|
Old Thread Alert!
The last post was made 3 years, 282 days ago. Instead of replying here, would creating a new thread be more useful? |
|
|
|