nsr forks on a ns?

[Welshd1k]

can it be done and still use the ns wheel caliper etc?

they look simular but is the rest of the stuff such as caliper in same position?
____________________
Current >Cb600fx hornet, ns125rk90 21.7bhp@wheel<
Sold >,zxr400 h2 (33bhp kit) rd350 n1 rd350 lc2<

[alains]

i am surprised about your bike , you said NS125RK year 1990 . the made of NS125 was stopped in 1988 (model TC01) then comes the JC20 in 1989 and finally the JC22 in 1993 until 2001
may be you can fit JC20 forks on a TC01 , dont think about the caliper , you may find a complete wheel and caliper at bargain on EBAY . just take the length of your forks and compare if you have less than 1" difference it will not be a problem . the yokes are more important especially the diameter of the forks grips
____________________
the worst day fishing is better than the best day working

[hmmmnz]

i think the forks ect will fit into the yokes as they are the same diameter, but as you mentioned calipers may be an issue, as well as the axle size, i can only assume they are thee same,
like most bikes during the life of production the seem to change the caliper at one point or another.
the nsr disc is 318mm in diameter so measure yours and see if its the same.
if it is chances are every thing will fit, or mabee a new caliper as well might be needed
____________________
the humans are dead
I kick arse for the lord
Wiring Diagrams BIDNIP it bitches

[Kickstart]