Removing fork top bridge/top yolk + ignition problem.

[-Savage-]

Poop, I was repairing a wire which had burnt itself out just below my ignition. The Wire was one of three coming from the imobiliser (HISS) into the wiring loom. The wire has been soldered now, and seems to be a good job.


How-bloody-ever, whilst doing this, one of the other wires decided to detach itself from the bloody imobiliser barrel thing! So now I'm left with a wire, and a wee tiny stub of a wire on the imobaliser that I have to solder. This is obviously made much more difficult, as the wires enter the bottom of the imobiliser, thus i would like to remove the top yolk, and the imobiliser along with it.

i have the stem nut off, and already had the forks removed, but the yolk seems not to want to budge. I've hit it a bit with a hammer, but not really getting very far.

just wondering if this is right, service manual says "remove stem nut and remove fork top bridge."
____________________
My Bikes - - - Royal Enfield 500 with sidecar, VFR800, CBR600FX,
Peugeot Speedfight 100, Kymco Hipster 125, GSXR750K5, Jawa TS 350