slidey slidey

[Demonic69]

I need to nail the back wheel to the floor
The fookin thing slipped well out earlier, I think I put the power on a little too quick. Looked like a fooking pro as I swung it round the corner though.
Great fun!
____________________
Back on a Blade. Just feels so right.

[G]

Try 140ish hp, seriously down geared

I've been doing little burnouts when I leve home/work so I ge t alittle tracftion for the mile to and from home/work :S

If I pull the throttle on full it just wheel spins as it goes into teh powerband and often when I'm being gentle as well :S
Not properly warmed up 207GPs in wet/cold conditions doesn't help.

[Demonic69]

LOL, I caned it in 2nd and the back went again. Took it a lil easier after that one
____________________
Back on a Blade. Just feels so right.

[Doddmaster]

Just be thankful you dont have a Hi-Max tyre. My front slides more than the rear

[Scotty]

Least you have tyres...
My rear ones shagged and has a puncture in it.
Its current PSI is 7...

And stays at its normal pressure for about 2 days...
____________________
Regards
Scott

[Ste]

isnt life hard g zx9r...

luckily i dont have this problem much with the nsr, until its snowing and i find myself going sideways

roll on summer

[G]

I had the back go when almost vertical on the NSR a few months ago... the tyres were fucked though and the road was dry but pretty cold.
I quite got into 'rear wheel steering' on the NSR on every roundabout on the way to work (when I worked in Henly) on one damp morning, until I was about 50m away from work and leant it a bit *too* far with a little too much power on, add in the dodgy pot holed roads and I got a smashed mirror, didn't hurt myseld 'cos I was quite near the ground at the time anyway .