Clutch on a 50cc Beta

[Proview]

Right well i have got this Beta in my garage and it didint start so me and my mate cleaned the carb and changed the fuel line (old one was split and cracked ) cleaned the air filter etc etc so after many hours of messy work it started so i pulled the clutch and put it in to 1st and it stalled so i thought it might of been me so i started it again and the same thing happened so now what we do is start it push it about 5 foot jump on and put it in to gear and whay hey off we go

So my question is whats wrong with the clutch and i have ajusted it but nothing
____________________
Aerox R 50cc 2008 ,Aerox RR 2002, Mbk Nitro 2001, Beta RRT Elf racing series ,1989 Beta trueba Needs fixing
! ! ! -Pat- ! ! !
Gonna wrap a teatowel around the lid nextime..y'know for relgious reasons

[The Artist]

rev it a bit aswell as letting go of the clutch

[ms51ves3]

Is the cable adjusted properly?

Could be that the cable is so slack that when you pull it the clutch isn't disengaging.

[Proview]

It is ajusted and when i pull the cable it goes to the maximum and still nothing

Could it just be very worn ?
____________________
Aerox R 50cc 2008 ,Aerox RR 2002, Mbk Nitro 2001, Beta RRT Elf racing series ,1989 Beta trueba Needs fixing
! ! ! -Pat- ! ! !
Gonna wrap a teatowel around the lid nextime..y'know for relgious reasons

[The Artist]

folow the cable down to the clutch arm on the engine. Look at it when you pull the clutch lever in. Does it move? Can it move more?

[Proview]

yep when i pull it ,it goes all the way back and if i try to move it more back with my finger it doesnt go any further
____________________
Aerox R 50cc 2008 ,Aerox RR 2002, Mbk Nitro 2001, Beta RRT Elf racing series ,1989 Beta trueba Needs fixing
! ! ! -Pat- ! ! !
Gonna wrap a teatowel around the lid nextime..y'know for relgious reasons

[ms51ves3]

Looks like you're going to have to open it up and investigate.