help with rear wheel cush bearings and clutch cable

[rockers]

hi there chaps, brought the cush bearings ive been needed for my rear wheel as it developed alot of slack in the studs, my question before i try and change them, how easy is it done ? is it a matter or popping the old ones out and putting new ones in, should i grease atall ?

also my clutch cable up by the levers is broken a small amount a thew strands are broken 3-4 so i would like to replace it, the ajustment bit on the lever broke so i gess thats whats done it,
my bikes a kymco stryker 125 so anyone know where i could find a clutch cable for it i cant find any websites that sells spares and ebay have nothing any ideas ?

[Kickstart]

Hi

No need to lube the cush drive rubbers. They probably just sit in place, but might have a locating "mushroom" going into a hole.

With the cable you probably need to sort the adjuster at the same time.

All the best

Keith
____________________
Traxpics, track day and racing photographs - Bimota Forum - Bike performance / thrust graphs for choosing gearing