That'll be broke then..

[Pete.]

Gilera SP50 needs a new crank, piston & barrel
____________________
a.k.a 'Geri'

132.9mph off and walked away. Gear is good, gear is good, gear is very very good

[sickpup]

Stop being a drama queen. They're standard service parts on one of those.

[Pete.]

[sickpup]

Sorry I tend to keep away from that kind of stuff but...

Crank is about £75 and I don't know if it includes the con rod or bearings so will have to check but should.

The standard barrel I have to check the price and see if it comes with a piston kit.

Small ends come in a pack of 5 £20

Gasket set is £10

If you make a complete list of what's needed I can try and get you prices tomorrow morning.

[Pete.]

Basically whats in the pic. There's a bit of a ding in the transfer ports but nothing to worry about. I could possibly press the pin out of the crank and fit a new rod on the crank if I could get one, have to check out the crank when I split the engine.

Looks like over £100 for parts which is dangerously close to 'scrap it' territory
____________________
a.k.a 'Geri'

132.9mph off and walked away. Gear is good, gear is good, gear is very very good

[Pete.]

Oh, also need a lock set.
____________________
a.k.a 'Geri'

132.9mph off and walked away. Gear is good, gear is good, gear is very very good

[chillpill]

how the feck did that happen ? was the crankshaft made of fudge

[L3G3ND_MTX]

Bit of duct tape and it will be fine

[Blau Zedong]

Only an 8 out of 10 I'm afraid as you didn't punch a hole in the crankcases.

Sorry.
____________________
18:54:48 Rob Fzs: jews don't give away stuff for free

18:54:59 Rob Fzs: unless its their clothes/ hair/ golden teeth