YBR tail light

[fiery tupp]

Just a daft queerie !... Ive just been checking around , new to me 08 Ybr 125 & the back light was as floppy as a limp duck ! I know lights need some damping but this seemed way to way to loose . So seat off & the nut were tight , so it must have always been like it , surely this can't be the norm for these Ive had a good few bikea & none ever like it ? it must have been bouncing about like Jordan on a road drill . Anyway I put a couple more rubber washers on & set it to what I think should be about right for it & I suppose I'll find out if bulb dont last long , but just wondered if anyone else had noticed theres were the same ?
____________________
If you can't fix it with a hammer , use your head .

[Paxovasa]

Is / was it the whole light fitting or just the lense?
____________________
Suzuki GSF600 K3 (in the fastest colour, black).

[fiery tupp]

The whole fitting , ended up having to take seat , rack & back pannels of to get to it propperly
____________________
If you can't fix it with a hammer , use your head .

[Asharin]

The YBR I had as a hire bike for 2 weeks was like that too.

[fiery tupp]

Well this one I have just got is 2 year old but only done 650 miles & mint , it was just used with camper van a few of times . I dont think the light like it was would have lasted a few K miles ? but like I say I dont know if it is how they are made ?
____________________
If you can't fix it with a hammer , use your head .

[Mark65]

Hi
I wouldnt say mine flops about but it does have movement by hand, i assume its to stop shocks going through it.
Mark
____________________
07 Yamaha YBR125, 07 Honda CG125 , 15 CBR300R (Chocolate Crank, Deaded), 16 CB500FA, 19 Honda Forza 300, 70 Suzuki SV650