What other engines will drop into a CR250 frame?

[sandman1976]

Basically as the title says, cant afford to do it yet but would be good to be ready armed for when i do

Ta

[Teflon-Mike]

Given a welder, an angle grinder, pipe bender, vice, files, a little tubing, bit of sheet, a bit of know how and a lot of skill.....
Almost anything you facied.... from a C50 engine up to a CBX-6....
____________________
My Webby'Tef's-tQ, loads of stuff about my bikes, my Land-Rovers, and the stuff I do with them!
Current Bikes:'Honda VF1000F' ;'CB750F2N' ;'CB125TD ( 6 3 of em!)'; 'Montesa Cota 248'. Learner FAQ's:= 'U want to Ride a Motorbike! Where Do U start?'

[hmmmnz]

pretty much any 2 stroke water cooled motor should go in with out too many hassles, a honda motor will give you the best of the mounts lining up
i beleive the cr500 motor etc is almost a direct swap, but there are expensive
____________________
the humans are dead
I kick arse for the lord
Wiring Diagrams BIDNIP it bitches

[sandman1976]

What about an old YZ250 engine?

[Teflon-Mike]