 |
|
 |

|
|
| Author |
Message |
| TheDonUK |
This post is not being displayed .
|
 TheDonUK World Chat Champion

Joined: 20 Feb 2006 Karma :   
|
 Posted: 14:07 - 25 May 2011 Post subject: Steering Damper/ Harris Kit Fitting |
 |
|
I just picked up a Ohlins Steering Damper and Harris fitting kit but have no idea about the mounting, cant seem to find any guides online...
Edit: 99 R1 ____________________ [Current Bikes - GSXR-750 K5 & C90-97 ] [Previous Bikes: Runner 125, YBR 125, GS500, Bandit 600, Hornet 600, ZX6R-99, C90-99, R1-99, XT600E-04, GSXR-750 K4, CRF250L '16] |
|
| Back to top |
|
You must be logged in to rate posts |
|
 |
| tatters |
This post is not being displayed .
|
 tatters Exxon Valdez

Joined: 04 Jan 2004 Karma :   
|
 Posted: 14:12 - 25 May 2011 Post subject: |
 |
|
Looks the same mounting method as the ohlins dampers l had on my 954 fireblades.
The bracket with the large diameter hole goes under the steering yoke nut (sits on top the the yoke) and the other bits normaly allow you to connect the damper to the from fuel tank mount, easy to do but hard to explain. ____________________ Past:NRG50,AF1125(x2),NSR125RR,ZZR250,CX500,VFR400,KR1S,ZZR600(x2),CB400N,YZF1000(x2),KH125,Z200,FX400R,CBR954RR(x2)GPZ500S,GT550,VFR750F(x2),RD350N,XR650R,CBR600F,CB250,KDX250,YZF750R,CRM250,400EXC,KLR650,TTR600RE,DR350S,R100GSPD,RGV250,VMAX1200,DL650,KZ750 Present:G650XC,C12,CRF450X,1190ADV |
|
| Back to top |
|
You must be logged in to rate posts |
|
 |
| TheDonUK |
This post is not being displayed .
|
 TheDonUK World Chat Champion

Joined: 20 Feb 2006 Karma :   
|
 Posted: 14:18 - 25 May 2011 Post subject: |
 |
|
Yeah i see what you mean about 50%, it sits on the yoke and proves two rear mounting points, also reckon the bit on the far right connects to the bearing end of the damper, i might just order new headrace bearings and take the lot into get done... ____________________ [Current Bikes - GSXR-750 K5 & C90-97 ] [Previous Bikes: Runner 125, YBR 125, GS500, Bandit 600, Hornet 600, ZX6R-99, C90-99, R1-99, XT600E-04, GSXR-750 K4, CRF250L '16] |
|
| Back to top |
|
You must be logged in to rate posts |
|
 |
| tatters |
This post is not being displayed .
|
 tatters Exxon Valdez

Joined: 04 Jan 2004 Karma :   
|
 Posted: 14:23 - 25 May 2011 Post subject: |
 |
|
If you bring the bike to me l can fit the damper as from your profile your not that far away.
I,m in
West molesey, Surrey ____________________ Past:NRG50,AF1125(x2),NSR125RR,ZZR250,CX500,VFR400,KR1S,ZZR600(x2),CB400N,YZF1000(x2),KH125,Z200,FX400R,CBR954RR(x2)GPZ500S,GT550,VFR750F(x2),RD350N,XR650R,CBR600F,CB250,KDX250,YZF750R,CRM250,400EXC,KLR650,TTR600RE,DR350S,R100GSPD,RGV250,VMAX1200,DL650,KZ750 Present:G650XC,C12,CRF450X,1190ADV |
|
| Back to top |
|
You must be logged in to rate posts |
|
 |
| TheDonUK |
This post is not being displayed .
|
 TheDonUK World Chat Champion

Joined: 20 Feb 2006 Karma :   
|
 Posted: 14:46 - 25 May 2011 Post subject: |
 |
|
Nice one, PM Sent ____________________ [Current Bikes - GSXR-750 K5 & C90-97 ] [Previous Bikes: Runner 125, YBR 125, GS500, Bandit 600, Hornet 600, ZX6R-99, C90-99, R1-99, XT600E-04, GSXR-750 K4, CRF250L '16] |
|
| Back to top |
|
You must be logged in to rate posts |
|
 |
| tatters |
This post is not being displayed .
|
 tatters Exxon Valdez

Joined: 04 Jan 2004 Karma :   
|
 Posted: 20:43 - 27 May 2011 Post subject: |
 |
|
All fitted and working, took some time to figure out were all the bits went without a manual but got it in the end.
TheDonUk also manged to drop his bike when pulling away from my house.
https://www.youtube.com/watch?v=HJfB-q7Gb2M ____________________ Past:NRG50,AF1125(x2),NSR125RR,ZZR250,CX500,VFR400,KR1S,ZZR600(x2),CB400N,YZF1000(x2),KH125,Z200,FX400R,CBR954RR(x2)GPZ500S,GT550,VFR750F(x2),RD350N,XR650R,CBR600F,CB250,KDX250,YZF750R,CRM250,400EXC,KLR650,TTR600RE,DR350S,R100GSPD,RGV250,VMAX1200,DL650,KZ750 Present:G650XC,C12,CRF450X,1190ADV |
|
| Back to top |
|
You must be logged in to rate posts |
|
 |
| TheDonUK |
This post is not being displayed .
|
 TheDonUK World Chat Champion

Joined: 20 Feb 2006 Karma :   
|
 Posted: 23:31 - 27 May 2011 Post subject: |
 |
|
Harsh, and on youtube
Cheers for getting it sorted though, Getting to grips with the damper... ____________________ [Current Bikes - GSXR-750 K5 & C90-97 ] [Previous Bikes: Runner 125, YBR 125, GS500, Bandit 600, Hornet 600, ZX6R-99, C90-99, R1-99, XT600E-04, GSXR-750 K4, CRF250L '16] |
|
| Back to top |
|
You must be logged in to rate posts |
|
 |
| potato |
This post is not being displayed .
|
 potato Crazy Courier

Joined: 21 Feb 2007 Karma :    
|
 Posted: 02:13 - 28 May 2011 Post subject: |
 |
|
Wtf are you doing on an r1......  ____________________ OOOooosshh! |
|
| Back to top |
|
You must be logged in to rate posts |
|
 |
| Ichy |
This post is not being displayed .
|
 Ichy World Chat Champion

Joined: 15 Jul 2005 Karma :     
|
 Posted: 07:35 - 28 May 2011 Post subject: |
 |
|
What happened there? Just loss of balance or stalled? Having short legs I've done this loads of times. Dumbest was deciding to let the bike free wheel down a hill, backwards. I was fine until I tried to turn the corner.  ____________________ https://www.metacafe.com/watch/1972097/how_to_behave_on_a_forum/ |
|
| Back to top |
|
You must be logged in to rate posts |
|
 |
| TheDonUK |
This post is not being displayed .
|
 TheDonUK World Chat Champion

Joined: 20 Feb 2006 Karma :   
|
 Posted: 08:24 - 28 May 2011 Post subject: |
 |
|
What happened was being short and not pointing it in the direction i intended to go.
I dont think it stalled, just lost balance...
At least the its not only tatters that gets to laugh at it...  ____________________ [Current Bikes - GSXR-750 K5 & C90-97 ] [Previous Bikes: Runner 125, YBR 125, GS500, Bandit 600, Hornet 600, ZX6R-99, C90-99, R1-99, XT600E-04, GSXR-750 K4, CRF250L '16] |
|
| Back to top |
|
You must be logged in to rate posts |
|
 |
| robocog |
This post is not being displayed .
|
 robocog Traffic Copper
Joined: 17 Apr 2009 Karma :   
|
 Posted: 09:31 - 28 May 2011 Post subject: |
 |
|
That's harsh
Hopefully just your pride and dignity scuffed and the bike has no damage
When I saw the vid I wondered if it was the damper that caused it
Looked similar to a no speed drop I made when I forgot the steering lock was on
OT - Tatters have we met?
(I bought a DR250 engine off eBay from a guy in West Molsey a few months ago and came over and collected it)
If so barrel /piston and top end fitted I'm back up and running like a dream
Regards
Rob ____________________ Needs a bigger garage... |
|
| Back to top |
|
You must be logged in to rate posts |
|
 |
| TheDonUK |
This post is not being displayed .
|
 TheDonUK World Chat Champion

Joined: 20 Feb 2006 Karma :   
|
 Posted: 10:30 - 28 May 2011 Post subject: |
 |
|
The damper dident cause it, a contributing factor no doubt. As the steering feels very different. I did go for a ride after the embarrassment at tatter's and am more confortable with it now.
I think what that was is simply a fail. New ish clutch, short legs, stupid angle to pull away from and not enough revs.
Havent dropped a bike in years so i guess i was due...
Why couldent i have done it 10 meters up the road out of view of that bloody camera...  ____________________ [Current Bikes - GSXR-750 K5 & C90-97 ] [Previous Bikes: Runner 125, YBR 125, GS500, Bandit 600, Hornet 600, ZX6R-99, C90-99, R1-99, XT600E-04, GSXR-750 K4, CRF250L '16] |
|
| Back to top |
|
You must be logged in to rate posts |
|
 |
| ryhardcastle |
This post is not being displayed .
|
 ryhardcastle Scooby Slapper

Joined: 20 Jun 2009 Karma :     
|
|
| Back to top |
|
You must be logged in to rate posts |
|
 |
Old Thread Alert!
The last post was made 14 years, 293 days ago. Instead of replying here, would creating a new thread be more useful? |
 |
|
|
This page may contain affiliate links, which means we may earn a small commission if a visitor clicks through and makes a purchase. By clicking on an affiliate link, you accept that third-party cookies will be set.

|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum You cannot attach files in this forum You cannot download files in this forum
|
Read the Terms of Use! - Powered by phpBB © phpBB Group
Debug Mode: ON - Server: birks (www) - Page Generation Time: 0.06 Sec - Server Load: 0.6 - MySQL Queries: 14 - Page Size: 77.04 Kb
|