Anyone own a CG125/YBR125?

[garth]

I need a favour.

I need to know the distance in mm between the end plates - i.e. Where you put the wheel spindle through.

It's for my NSR Cub, I need to use a wider swing arm and offset it to clear the chain - With a spaced out drive.
____________________
You ain't a has been if you never was

[deleted111]

I've got a CG. Not promising anything but I'm on lunch at the minute.

I'll borrow a tape measure from one of the engineers and run outside if poss.

[deleted111]

Fully enclosed chain guard has stopped me in my tracks - can't get you an accurate measurement, really.

I'm home just after 6pm - if nobody else comes along with a figure then by all means I'll take the guard off and measure for you. Need to take the wheel out anyway.

Cheers,

Steve.

[garth]

Nice one - Roughly is fine. Chain adjuster - Chain adjuster would be fine.
____________________
You ain't a has been if you never was