gs500 carb spitting?

[dransy]

Hi guys , after my last post of getting shit loads of fuel in my oil i replaced the float needles/valves gaskets and O rings and that problem has gone

Now though one of my plugs is fine and the other one is really black and sutted .

Also at low revs , i can hear the carbs spit , mainly when doing a U turn , ive read up abit what i can and it says this happens when the mixture is lean. I set both mixture screws to 2.5 turns out and also checked the float heights.

The next thing i was going to do is balance the carbs , could this solve my problem ? the carbs are old but over the past few months ive had them apart and cleaned them loads of times because of my previous problem with fuel in the oil.

Cheers
Marco
____________________
Being shot out of a cannon will always be better than being squeezed out of a tube. That is why God made fast motorcycles

[Vincent]

You've checked the air filter?
____________________
Space Is Deep

[dransy]

What am i checking for? Its a new filter thats in , or do you mean where it seals onto the carbs?
____________________
Being shot out of a cannon will always be better than being squeezed out of a tube. That is why God made fast motorcycles

[Vincent]

Just checking the filter is good.
____________________
Space Is Deep

[orac]

did you balance them?? if not make sure they are well balanced
____________________
Current rides - 2016 Triumph Street Triple Rx, 1994 Suzuki Bandit 400 VM, TGB 204 Classic 125cc
"with nothing left to lose, there is everything to gain. It's not the size of the dog in the fight, it's the size of the fight in the dog"