FS: DR350 project/spares

[Adamantis]

MAKE ME AN OFFER - I might even get some pics if you're lucky! I need cash, and I need it gone...

I am finally going to admit that I can't be bothered and it needs to go :p

1994 DR350 with road wheel conversion (RGV250 wheels, was done professionally by a previous owner).

By the look of it, the piston rings went kerplunk, and it was drinking oil at a pretty rapid rate, so I took it off the road to have a look. OH started dismantling it, but didn't get very far.

That was coming up to a year ago...

It has since been sat in the garden with a cover over it, and half the bolts/engine covers are in a bucket in the bathroom...

Yeah.

I'm don't have the time or inclination to repair it, as the purpose for which I bought it no longer exists!

Ideally I'd like 500 quid - it was a good little runner (if a bit rich) before this happened, and I', pretty sure whoever can be arsed will get a nice little bike out of it. It was rebored before I bought it, but I was never advised what to - which is where part of my "I can'tbe arced" comes from :/

Make me an offer - I need the space for the BBQ!

(SW London, you'll be needing a van)
____________________
Rides: '91 CG125 (Sold), '00 CB500S (Sold), '97 Thundercat (Sold), '99 KTM EXC 300 (SOLD), '99 RSV Mille (stolen. Thieving SCUM!!!), '94 DR350 (sold), '10 Vstrom 650 (hated it so much I gave up riding), now on the OH's CBF1000 until I can afford another Mille...