|
|
| Author |
Message |
| charrington96 |
This post is not being displayed .
|
 charrington96 Borekit Bruiser
Joined: 10 Nov 2013 Karma :     
|
|
| Back to top |
|
You must be logged in to rate posts |
|
 |
| _Iain_ |
This post is not being displayed because the poster is banned. Unhide this post / all posts.
|
 _Iain_ Banned

Joined: 01 Feb 2012 Karma :     
|
 Posted: 17:36 - 03 Mar 2014 Post subject: |
 |
|
If it would pull the 14 perfectly fine and now it mysteriously doesn't I'd suspect something else is up with it. ____________________ Please be aware that the above post may be full of complete nonsense.
Riding: '07 KTM Duke II, Baotian BT49QT-20 Driving: '88 Volvo 340 |
|
| Back to top |
|
You must be logged in to rate posts |
|
 |
| charrington96 |
This post is not being displayed .
|
 charrington96 Borekit Bruiser
Joined: 10 Nov 2013 Karma :     
|
|
| Back to top |
|
You must be logged in to rate posts |
|
 |
| _Iain_ |
This post is not being displayed because the poster is banned. Unhide this post / all posts.
|
 _Iain_ Banned

Joined: 01 Feb 2012 Karma :     
|
 Posted: 18:22 - 03 Mar 2014 Post subject: |
 |
|
Okay,
You're missing something so lets start again.
If you ran a 14t front sprocket on it, and could run around doing 50-55mph all day long, and then one day it won't do it anymore but the sprocket hasn't been changed then the gearing isn't the issue.
I suspect if they're suggesting a top end rebuild is due then it's probbably worn out, lost compression and the engine just isn't making enough power anymore to pull the gearing. You can test this by checking the engines compression, and comparing the reading to what the manual suggests it should be. If it's miles out then time for a rebuild!
Engine rebuild times vary massively.
My CR125 (Two stroke) has a very highly strung motor in it, it makes 40 odd horsepower but needs a top end rebuild every 15hrs of run time.
My H100 (Two stroke) was a very mildly tuned commuter bike, it made around 9-10 horsepower and rebuilds were done when needed, however the original top end had done 8,000 miles before it siezed up on me on a top speed run.
My YBR125 (Four stroke) was a mildly tuned commuter bike that made around 11 horsepower. It had 17,000 miles on it and had never been rebuilt when I sold it - It probbabbly needs a rebuild now as it's current owner ended up on here pouring dirty oil with bits of metal in it back in the engine...
With your bike being what it is, and you claiming to have hit speeds of 50-55mph, I'd suggest it's being thrashed - so the service life of a top end is going to be reduced significantly.
https://www.adrenalin-pedstop.co.uk/upload/359x359/eebb2-STP845.JPG.jpg
A kit like that will cost between £70 and £90. Not too much work to change either, shouldn't take more than a few hours.
HTH  ____________________ Please be aware that the above post may be full of complete nonsense.
Riding: '07 KTM Duke II, Baotian BT49QT-20 Driving: '88 Volvo 340 |
|
| Back to top |
|
You must be logged in to rate posts |
|
 |
| charrington96 |
This post is not being displayed .
|
 charrington96 Borekit Bruiser
Joined: 10 Nov 2013 Karma :     
|
|
| Back to top |
|
You must be logged in to rate posts |
|
 |
Old Thread Alert!
The last post was made 12 years, 262 days ago. Instead of replying here, would creating a new thread be more useful? |
 |
|
|