oil seal change, crankshaft. stuck..

[770]

Husqvarna SMS 125.

I am trying to remove the oil seal on the right side of the crankshaft, it was completely stuck so most of it is now torn apart. But there is still a thin layer in there, any tips on how to get it out??

pictures:

https://postimg.org/image/dpptegh4x/


https://postimg.org/image/9hv15pfpd/

[_Iain_]

Gently tapping with a screwdriver & applying heat to the cases is what I'd try.

Double check you're trying to get it out the right side though!
____________________
Please be aware that the above post may be full of complete nonsense.
Riding: '07 KTM Duke II, Baotian BT49QT-20 Driving: '88 Volvo 340

[serlant]

A socket smaller than the size of the hole big enough that it hits the oil seal, i'd also use a little bit of heat on the case.
____________________
04 CBR1000RR, 1995 Husqvarna TE410, 1998 VTR1000(Sold), 1990 XJ600(sold), 1996 KH125(dead and sold)