GPZ 500 sprocket carrier bearing

[nigel_robbins]

Hi,
Anyone know the part number since mine needs replacing.
The model is GPZ 500S D6.
Many thanks,
Nigel

[pompousporcup...]

https://www.wemoto.com/bikes/kawasaki/gpz_500_s_ex_500_d1-d7_uk_market/94-01/picture/sprocket_carrier_bearing/

This any good?

[nigel_robbins]

Thanks for the link but I'm looking to buy one from the local bike shop tomorrow but they want the part number

[Pete.]

[Casper]

Looks like one size fits all

Inside:32mm x Outside:52mm x Width:15mm

https://www.ebay.co.uk/itm/Kawasaki-GPZ500-S-87-04-Sprocket-Carrier-Bearing-073165-/180932589298?pt=LH_DefaultDomain_3&hash=item2a206c36f2

Dont buy that overpriced shite in the link. Give the sizes to your shop

[nigel_robbins]

Thanks for all the replies.
I had the day off. So, to get the job done, I bought one from the local bike dealer for £10.
The part number was 6205 2RS.

[Ed Case]

When it comes to bearings and oil seals these are normally International sizes and numbers. Seals are sold by dimensions, outside diameter/inside diameter/width in millimeters. These are usually available at your nearest bearing stockist at a price much less than at a bike dealer. Some seals on bikes have a 'double lip' as in fork seals where the 'upper lip' scrapes any road crap etc off the bare leg and are more easily obtained from a bike dealer as they usually not everyday stock in most bearing outlets.
As an example I wanted four seals for Marzocchi 38mm forks (standard International sized)......Laverda dealer £5.00 each...bearing stockist £5.50...for four !.