Sprocket sizes

[SeeGee125]

After further investigation into the bikes bad performance have now found that's it's running a sprocket set up of 16/38 as opposed the standard 14/41which will hinder the quite alot I have been told.

So. My question is, what front sprocket woukd you use to recreate the 14/41/,ie would 13/38 give the same gearing as standard if that makes sense, and do the cg125 use the same sprocket /chain as the c90.

[Northern Monkey]

Honda know more about motorbikes than you do. Use the OEM sproket sizes
____________________
Fisty: after polishing the tank with the glistenng beads of sweat from my full hot scrotum, I filled the headrace bearings with 10cc of my manmilk

[Monkeypony]

13/38 would not be the same, but a damn sight closer to stock than 16/38!

There are plenty of combinations that would give you the same gear inches as stock, but why not just use stock?

If you want to only change 1 sprocket, you'll be looking at 16/47.

You can't match the gearing by keeping a 38 tooth rear sprocket.
____________________
Current bike - 2018 H2-SX, 2004 SV1000s, 2016 Aprilia RSV4 RF, 2017 Sherco SERF 300, 2003 Suzuki DRZ400 (stolen - AY53 JUU)

[SeeGee125]

Just a thought bud that's all, an the cheapest option lol, tight twatt I am. Ha ha. Stock it is then. Where's the best place, Ebay??