Honda CB125tde Superdream advice

haydo720 · L Plate Warrior Joined: 23 Sep 2015 Karma :

hi guys,
I'm new to this forum so please excuse if this has cropped up in the past. I have just purchased a cb125tde superdream. The bike is a little bit rough around the edges and in need of a rebuild and I am sure that the carburettors have had it Crying or Very sad

. I know for sure that the inlet rubbers are shot and I know that their as rare as rocking horse ...manure! I want to know if an inlet manifold and carburettor from a cm125t (2 into 1) would fit and work on my bike? As there is a chap on ebay who is selling one.

Any help would be brilliant

nowhere.elysium · The Pork Lord Joined: 02 Mar 2009 Karma :

InB4 wall of sperg.
____________________
'10 SV650SF, '83 GS650GT (it lives!), Questionable DIY dash project, 3D Printer project, Lasercutter project

stinkwheel · Bovine Proctologist Joined: 12 Jul 2004 Karma :

The CM manifold with one of your CB carbs (the one with the choke lever) will work.

Tight for space because of the monoshock. You land up ditching the airbox, fitting a pod filter and finding somewhere else to keep the battery.

Runs remarkably well. Better than before in some cases because it's perfectly balanced compared to a pair of unevenly worn carbs.

I know because I've done it.
____________________
“Rule one: Always stick around for one more drink. That's when things happen. That's when you find out everything you want to know.”
I did the 2010 Round Britain Rally on my 350 Bullet. 89 landmarks, 3 months, 9,500 miles.

haydo720 · L Plate Warrior Joined: 23 Sep 2015 Karma :

thanks stink wheel for the reply. sounds good, to me but will I have to fiddle with jetting with a pod or cone filter? battery shouldn't be a problem I can probably fabricate a cradle to hold it.

stinkwheel · Bovine Proctologist Joined: 12 Jul 2004 Karma :