Chips in powder coat

[A100man]

Can anything be done to stop the rot..

.. we all know that once the (salty) water gets in and behind - the powde coat is shed. Can chips be touched like paint or even with paint?
____________________
Now: A100, GT250A, XJ598, FZ750

Then: Fizz, RS200, KL250, XJ550, Laverda Alpina, XJ600, FZS600

[BanditsHigh]

Don't see why not ... your standard rattle cans would take a few coats to build a decent layer up ... might be better to get a pot of enamel paint and touch it up with a small brush, should be harder than the powder coat.

All the best ... Barry

[stinkwheel]

I'd probably go with some poyurethane paint, it's hard as nails and sticks well to bare or even slightly rusty metal.
____________________
“Rule one: Always stick around for one more drink. That's when things happen. That's when you find out everything you want to know.”
I did the 2010 Round Britain Rally on my 350 Bullet. 89 landmarks, 3 months, 9,500 miles.

[Polarbear]

Id go fore those small pots of model enamel by Humbrol and a brush. They do loads of colours so a decent match should be easy
____________________
Triumph Trophy Launch Edition

[A100man]

Paint it is then! - black wheels so should be ok to match in
____________________
Now: A100, GT250A, XJ598, FZ750

Then: Fizz, RS200, KL250, XJ550, Laverda Alpina, XJ600, FZS600