indicator fitting help needed

[froggy128]

do i cut the original indicators and then put the 2 wires silver connector in the new indicators?

[Black Knight]

Hiya froggy,

You shouldn't need to cut any wires. Follow the cable back through from the indicator and it should come to a clip. Simply seperate this and attach the new blinker.

Is it on the 250? try and see what clips they have. post a pic if you can.

Rick

- Is it this one??
https://www.bikepics.com/pictures/429935/

Have your new indicators got the same clip on the end? You could change them over but it would be better to get new from a hardware shop.
____________________
Where does a turn end? 'Where you can do anything with the gas you want to, where you are brave again, where your attention is free from the turn, where you are sure you can do it better next time; that's the end' - Keith Code.

[froggy128]

yeh thats them they wont fit in the connectors so going to buy some new bits should look good when there on

[Black Knight]

Yeah, I did notice your blinkers were quite...noticable?

I have arrowed ones on the FZR. Something I didn't expect was with them being short stubs (really short) they barely could be seen as they sat behind the reg plate. Took a bit of bodging to get them to sit right.

Regards
____________________
Where does a turn end? 'Where you can do anything with the gas you want to, where you are brave again, where your attention is free from the turn, where you are sure you can do it better next time; that's the end' - Keith Code.

[froggy128]

thats why i got long stem ones i was wanting to get them on my bike for wednesday but never mind. While trying to fit them today i think ivve done something to the headlight, must have pulled a wire out as its not working now!

[Kickstart]

Hi

Check the headlight fuse. Fair chance it is the same fuse as the indicators and that you have earthed one of the ones and popped the fuse (that is assuming the indicators do not work either).

All the best

Keith
____________________
Traxpics, track day and racing photographs - Bimota Forum - Bike performance / thrust graphs for choosing gearing

[froggy128]

the indicators work but the lights dont so am guessing ive either discounted something or the light fuse has blown

[Teaman]

oops..

you have a bike mechanic who lives near you,,,,
you could always pop up and get him to laugh at it,,

personally it sounds like the light fuse as you shouldnt have touched anything else,,,
____________________
There is no point in ranting about someone stupid because there is nothing u can do about it. There is no cure for stupid.
Someone stupid does not realise they r stupid.stupidity is indistinguishable from malice U just have to accept that some people are thick as p1gsh1t and work around them.