RC Valves NSR

[OreoXX]

Hi

I was thinking of adjusting the RC valves of my NSR125, so I had a look in the Haynes manual. I followed its directions, but I couldn't seem to reach the valves. Do I have to take the whole engine off the frame to make this adjustment??

Thanks

[alains]

no , but if you start the whole process , you need to take off all fairings except back sides , tank & air box , radiator and open the base guide cover on the right side of the barrel .
look at the joined pict if your cables have the same position as describe on my file (download it https://www.geneva-racing.com/~alains/NSRtips.doc )
you can adjust also by this way :
- take off the air box , key on for 2 seconds then key off
- on the right side you will see the servo pulley . undo the screw on top (without moving the pulley) , and with a screwdriver used as a lever , lift it up .
- take off the right cable , refit the pulley without screwing it
- look the sharp notch position on the pulley (it must on "hi")
- now pull by hand the right cable and observe if the left cable pull a bit further
- if yes use the adjuster on the cable
____________________
the worst day fishing is better than the best day working

[John C]

There's a haynes manual

Do you have the manual number, as I can't find one.

Cheers

Sparkie

[DisabledRider]

yep i also wud like the number unless ur reading Honda NS125, as i think theirs a manual 4 tat.

[OreoXX]

There is no manual for the NSR125, but for the NS125R. The bikes have the same principles, just minor differences such as the carb. I find this manual helpful when working on my NSR, it seems the two bikes have a lot in common, but then I'm no NS125R expert

[John C]

No worries mate
I've allready got the NS125R manual