Exhaust question

[quik_d]

I was just browsing E-bay and came across thesehttps://cgi.ebay.co.uk/Suzuki-RGV-250-Exhaust-End-Cans-Excellent-Condition_W0QQitemZ8055669656QQcategoryZ10534QQrdZ1QQcmdZViewItem

, and started thinking about them on my bike, now i would have 1 can per header pipe. I have a set or carb balancers so could balance the carbs after if necessary, what are the implications of it?
____________________
LOOK AT DAT M8 WELL LUSH A PARROT INT IT

[edd]

is your bike a honda bros 400? if so i doubt those cans would be suitable at all, the rgv 250 is a 2 stroke, and will have an exhaust similar the the one found on say an rs 125. You would be better off loking for some 4 stroke end cans. you would probably be better off looking at something like these: https://cgi.ebay.co.uk/Art-Exhaust-Race-End-cans-and-link-pipes-ZZR-600_W0QQitemZ8055972676QQcategoryZ25623QQrdZ1QQcmdZViewItem
im not entirely sure of your exhaust setup, so you'd have to judge what you could make fit.
____________________
Bluespark Automotive - Diesel Tuning for Performance and Economy

[SoND]

The 2 stroke cans are a lot smaller than a 4 stroke. I suspect the pipe down the middle of them is going to be a fairly smaller diameter to what you will get with a proper can.

This will cause backpressure and the bike probably wont run right.
____________________
Go back to bed - You have no rights - "Streetfighters ~ Mainstream motorcycling's crackwhore sister."