turning a standard can into a race can ?

[colin1]

my standard can is dented and scratched so im probably gonna replace it with something off ebay.

rather than throw it away, would it be possible to rip out its innards to it just becomes a hollow tube and effectively a race can ?

id only use it occasionally so i dont want to buy a race can
____________________
colin1 is officially faster than god

[sickpup]

You mean modify it What would the triumph mechanic say?

[phantomtek]

Could this be done on an ER-5 can

Make it a tad louder?

[colin1]

[SoND]

Remember if you tear it apart you wont have one for MOT.

To make it like a race can you'll need to:-

Take the end off
Take everything out of it.
Fit a bit of perforated pipe down the middle.
Put some exhaust packing in it
Close it up again.

A loud, basic race can.
____________________
Go back to bed - You have no rights - "Streetfighters ~ Mainstream motorcycling's crackwhore sister."

[G]

If your can has a 'double exit' - ie an out and inner bit sticking out, a hole saw around the outer bit can work as you want.

May well even pass MOT, though it's down to their disgression - but it'll still be marked up.

[Kram]

If it's got a baffle stuck inside the can, you could drill the plate that holds it in (through the outlet) and pull it out, would give a louder sound
____________________
FS1E -> SR125 -> CB400N -> CB650 -> FZR600 Genises -> VFR400 NC21 -> CBR900RR Fireblade -> Renault Clio 1.4

[MikeH]

Did the XJR baffles last week sounds well nice and now has a nice large pipe exit instead of a pea shooter
____________________
Busa Junkie