Power Commander Installation

[The Dude]

Hi folks. i just fitted a power commander to my standard 2006 R6. I'm pretty sure it's fitted right. But when i rev the bike, the little green light on the Lean Rich scale doesn't move. I remember seeing my mates one and when he revved his bike the light shot up. Have i done something wrong?

[17-in-87]

Not sure if you can fit them wrong? Just checked mine though, the lights do move on the scale when you rev the engine. All your connections pushed home properly?
____________________
K1 GSX-R 600 - blue n white of course....

Growing old is compulsory - growing up is optional...

[The Dude]

Yeah. I fed the black plugs under the battery bracket and under the tank, plugged them into the correct connections. There were 2 other thin wires. One gets connected to the neg baqttery terminal and the other is like a little wire crimp that crimps onto the blue wire going into the ECU. I didn't wanna crimp it too hard incase it cut the wire. Whwn i start up the software i get the main chart, the fuel change on the right hand side and the duty cycle. But under Throttle % there is a 0 even when i rev the engine. Should i maybe crimp that ECU wire a little more? Should it actually pierce the insulation of that wire and connect with the actual wire inside? I was afraid i would cut the wire completely.

[The Dude]

Ok i have a theory. Could it be something to do with the 06 R6 having fly by wire throttle maybe? It aint the crimp thing. It's a wire tap, not an actual crimp. All the connections are fine. The fly by wire throttle is the only thing i can think of. Everything else is working fine