need some advice on inforad m1 problem... perhaps

[lydanial]

i have been using the inforad m1 for 2 years now on my ZX6r and will admit its great. however it seems to have developed a strange problem.

i travelled today to croft which was 120 miles on the motorway, anyway after about half an hour riding i looked at the inforad and noticed it was trying to reastablish a connection with satelite, it did this but then i noticed it repeating this over and over. finally it started flickering and acting strangly before going out. now what was strange was if i dropped my rpms/speed to about 6000/75 it would come back to life, but when i accelerated again it would die.
it carried this on all the time after a while. i thought this was an engine problem as it seemed to be kind of stuttering around these rpm's BUT then i realised this was when the power jumps in and i thought that perhaps it was because i was sat on the 'power band'? as dropping a little speed or speeding up a little made everything fine (engine wise not inforad)

on the journey home i started the bike and it fired up fine and seemed ok but within 15 minutes the inforad started playing up and flickering and no matter what i did it would not change. until it would just randomly come on warning me i was speeding ..(honest i wasnt )or flicker etc.. in the end i stuffed it behind the clocks and enjoyed the rest of the journey

any suggestions would be useful,

i asked my fellow riders to watch my lights etc to see if they were flickering or dropping low etc but they said all that seemed fine.


thanks

[sickpup]

If the inforad is plumbed into the bikes electrics this could be a sign of a charging fault.

[lydanial]

how would i test the bike is charging ok?