Resend my activation email : Register : Log in 
BCF: Bike Chat Forums


poppin' burblin' and cutting out... only when cold....

Reply to topic
Bike Chat Forums Index -> The Workshop
View previous topic : View next topic  
Author Message

krebsy
World Chat Champion



Joined: 01 Jun 2005
Karma :

PostPosted: 13:45 - 24 Sep 2007    Post subject: poppin' burblin' and cutting out... only when cold.... Reply with quote

Fired up the ZZR-600 at lunchtime and it started to run a bit rough, then popped and burbled somewhat and finaly it cut out as I rolled up to a junction. opened up the choke to max and it started, then closed it a bit and the bike cut out again 40 yards further down the road as I rolled to a stop at the next junction. Whacked the choke all the way open again and it fired up, then riding along at 20mph it kangarooed a bit until I closed the choke again.

Ok, the bike seems to not like running from a cold start but it used to be ok. 2 mins with the engine running with a tiny bit of choke and it's fine when I then close the choke and ride off.

So, what's causing it? it's only when the engine is cold so I'm thinking plugs first, then leads, then filter and then fuel feed as my checklist. I'm also thinking it might be gunge in the engine so will chuck in a good dose of redex carb/eng cleaner tonight as well. I doubt it's the carbs icing as it's not been that cold around here but you never know.

Any ideas?

Ta,

K.
____________________
What's my New Year's resolution?

1280 x 1024.
 Back to top
View user's profile Send private message You must be logged in to rate posts

Robby
Dirty Old Man



Joined: 16 May 2002
Karma :

PostPosted: 13:52 - 24 Sep 2007    Post subject: Reply with quote

My old GPX was behaving a bit like that after I washed it. I poured a bit of meths (about 50cc of it) into a full tank of petrol, and it started running ok. I assume some water got into my fuel tank when it was being washed, meths absorbs water.

This is happening as soon as you start the bike, so fuel feed shouldn't be a problem - you're starting with full float bowls.
Plugs is a possibility, so check/change them.
HT leads is also a possibility, give them a good spray with WD40.

Then see if it behaves.
 Back to top
View user's profile Send private message You must be logged in to rate posts

bish777
World Chat Champion



Joined: 11 Nov 2004
Karma :

PostPosted: 20:50 - 24 Sep 2007    Post subject: Reply with quote

drain the float bowls as a first measure, then put the fuel tap on prime for ten seconds, then back to on. That should rid you of gunk in the float bowls.
____________________
GSXR1100J
 Back to top
View user's profile Send private message You must be logged in to rate posts

krebsy
World Chat Champion



Joined: 01 Jun 2005
Karma :

PostPosted: 09:16 - 25 Sep 2007    Post subject: Reply with quote

cool, cheers for the advice. I'll add a splash of meths and give it a good dose of WD-40 where needed. Just need to find some plugs as my local stockist is out, oh and fix a toilet as well....

K.
____________________
What's my New Year's resolution?

1280 x 1024.
 Back to top
View user's profile Send private message You must be logged in to rate posts
Old Thread Alert!

The last post was made 19 years ago. Instead of replying here, would creating a new thread be more useful?
  Display posts from previous:   
This page may contain affiliate links, which means we may earn a small commission if a visitor clicks through and makes a purchase. By clicking on an affiliate link, you accept that third-party cookies will be set.

Post new topic   Reply to topic    Bike Chat Forums Index -> The Workshop All times are GMT + 1 Hour
Page 1 of 1

 
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You cannot download files in this forum

Read the Terms of Use! - Powered by phpBB © phpBB Group
 

Debug Mode: ON - Server: birks (www) - Page Generation Time: 0.06 Sec - Server Load: 0.41 - MySQL Queries: 13 - Page Size: 39.86 Kb