ZXR400 barends issue.

[MillaMeter]

As you peeps know I own a ZXR400L L2. Now I know this may sound stupid or disgusting, but I'm changing all the accessory parts on the bike to purple. e.g. levers, bolts, oil cap etc... Now I've done quite a lot already including tank bolts, screen and screen bolts, oil cap, levers and flush mount indicators.

Now the reason I opened this thread is to ask, is it possible to put barends on the ZXR400 clips-ons? and If so, how? Only I've looked at it from all angles and it looks like the clip-ons are machined out of 1 piece of metal.

Any ideas wil be greatly appreciated.
____________________
Currently Own:
2010 Kawasaki ZX6R RAF Performance Edition / 2008 Kawasaki Ninja 250 K8F

[baldy]

Is the bar solid? if so, you can buy those bar ends that fit with a m8 allen cap screw. A little bit of carefull drilling and thread cutting will do it.
____________________
One day i will rule the world, just not today.

[MillaMeter]

[baldy]

Just make shure that you find the centre of the bar end and drill perfectly straight. Otherwise it will look odd.
____________________
One day i will rule the world, just not today.

[Yoshi]

[TUG]

i've been looking at black spike and yamaha embosed black and carbon copy bar ends, but they all screw in, but the problem is the ones i currently have hav a bit of rubber that expands when you tighten it up so it grips the inside, i think one of my bars has the bit that is threaded missing. What can i do? I dont like the current bar ends and they need changing.
____________________
Haz ER-5, innit!

[Jrod]

Purple parts on a zxr400, you must be mad! (or a fucking copycat )

https://w1.bikepics.com/pics/2006%5C02%5C16%5Cbikepics-523074-800.jpg
https://w1.bikepics.com/pics/2006%5C02%5C15%5Cbikepics-522165-800.jpg

You can either cut them and tap some holes or fit bars off a ZX6R.

[binge]

Or just dont fit anodized tat because it looks dog shit.

[Jrod]

Better than dying your hair, faggot.

[TUG]