Revs slow down

[broomy12]

Right i think i might have a starched gear cable but i'm not sure. It seams when i pull the cluch in on any gear and when it idols it slowly goes down and i have to keep reaving it to keep it running. Is this because the cluch isnt fully desabled?

[Claud 14.7 to 1]

Yer or your clutch could be fukkukked. Plates wear down with use, so adjustment on the cables part is neccesary.

[craigT19]

possibly...but you would feel the bike trying to roll forward slighlty.

if you have a bike with more than one carb i would bet my right arm they need balancing. my ninja did exactly the same for a bit (until i found the idle screw )
____________________
Bikes owned :- 2001 nsr125, 1999 zx6r, 2006 yzf-r1, 2009 xmax 250, 2012 yzf-r1, 2015 MT-07
Current bike : - 2016 MT-10
BCF member pops. sadly missed 1945-2003

[broomy12]

I recon i'm in need of new plates then. Both the adjustment screws are fully out this means hole new plates or what. i'm not really best on bikes as this is my first one you see. Would help me if i had more information for this question. Thank you