Suzuki 1200 gsf Bandit problem will not start

[einwod]

Hey folks

I have looked throughout the forums but cannot find an answer to this one. I was out for a spin last weekend on a sunny day, gave the bandit a bit of a blast and brought her home and into the garage where it sat until last night when i went to start it. Symptoms are, ignition on lights work, fuses all checked and ok, cut off and stand switches working correctly, engine turns over, but will not start. Tried this till the battery went dead, its a good battery BTW. Charged up the battery overnight and tried it again this morning, still turning over, but this time i checked for a spark with another sparkplug plugged into the cable, no spark. My question is simple, are the coils gone and would it happen as abruptly as this or am i missing something very simple etc. Any help would be appreciated. Oh and anyone know just how much I should be spending on new coils if this is the case

Thanks

[chillyman0]

had the same problem after my re-build of the bandit 4, in my case the starter relay cable had torn off somehow and in turn the cdi doesnt know it needs to spark... check the wiring loom for the starter relay... follow it through and check its not snapped/rusty/loose etc
might help, might not
Aaron

[einwod]

Many thanks all help appreciated, will have a good check of this

[einwod]

[einwod]

Ok heres the answer to this issue at long last, it is the key switch, wd40 and lots of it has sorted this nightmare