Radiator sizes - KLR600

binge · Emo Kiddy Joined: 02 Jul 2004 Karma :

I'm needing a rad for my Pit bike. The sensible option would be to buy a couple of RM65 rads, Because my bike is based on the KLX110, Which shares the same plastics as the RM65. So the rads will fit behind the shrouds perfectly.

However, People are asking SILLY money for them on ebay etc.

I've seen a few KLR600 RHS rads going on ebay for around the £15 - £20 mark. Im just trying to gauge the size of them.

None of the sellers are replying because they are all motorbike breakers.

here is the rad I'm thinking of getting...

https://i.ebayimg.com/09/!BL,uT3wBGk~$(KGrHgoOKj!EjlLmZDmvBJfM!msQ4g~~_1.JPG

Can anybody tell me how big it is?

Ben

finpos · World Chat Champion Joined: 13 Sep 2005 Karma :

All rad caps on japanese bikes are the same size, you can probably measure one and guestimate of the picture...

f.

alan52 · Two Stroke Sniffer Joined: 21 May 2008 Karma :

I have a klr250, could be the same size. From Ebay.

I'll measure it today, but it'd be handy if you tell me exactly which sizes you want first. I'll probably make an arse of it if you don't.

binge · Emo Kiddy Joined: 02 Jul 2004 Karma :

Mainly the height.
But width would also be handy.

I need a rad which is about 10 or 11" tall (Maximum). And no wider than about 6".

Cheers

Ben

alan52 · Two Stroke Sniffer Joined: 21 May 2008 Karma :

I only measured the height of the rectangular section, that was just over 7", probably another 2 or 3" in total.

It's 5 and a half inch wide.

The holes that the plastics and the grill attach to are 4" apart. The holes for fixing to the the frame are 3 and a half inch from top to middle hole and 3 and 3 quarter inch from middle to bottom hole.