Adding a 12v socket to a 125..

[tvchimp]

Is there any reason I cant add something like this Twin 12v socket or would having 2 12v devices charging/powered at the same time do something bad for my battery/bike?

I don't think I'll ever need 2x sockets, but figured that I'd have my phone (which doubles as GPS/Sat-Nav) and then a spare socket incase I buy anything in the future which I want to use at the same time.

Or, would it be best just to go for a single socket?

Both are gonna cost me around £7 in total from ebay so not a major issue, but just wondering if I could get away with the twin socket to give me some play-room.

bike is a 1987 CB125TDE Superdream, just had a new battery and finishing off the engine rebuild (FFS!) once the gaskets turn up tomorrow (hopefully!). Have already planned a few trips in the next few months once the engine has run in 500miles and want to get a socket sorted and tested for then to make sure its running fine.

Cheers.
____________________
Bike: Currently Bikeless... Gahh

[truslack]

Should be fine, chargers like that tend to take a fairly small amount of current.
____________________
Current: Suzuki RG 125 Gamma, Honda H100, Triumph Tiger 800XC, Suzuki SV650 (minitwin)

[the95th]

just make sure you use the correct fuses... dont want to kill your phone/nav in the middle of no were.

also were abouts would you place them? i have a 125 superdream and was thinking about putting a few gizmos on her but i cant seem to find the space
____________________
2004 Rieju Rs2 Matrix 50cc, 1982 Honda CG125, 1986 Honda Cm125, 1982 Honda Cb125..... I kill a lot of 125's

[tvchimp]