Kawasaki GT550 Oil Cooler

[EmacD]

Kawasaki GT550 G7 Oil Cooler problem, I have an oil leak on the Oil cooler, and there seems to be a lack of decent replacements available at what I would consider a reasonable price, considering S/H ones may be not that far away from the state my own one is in. So I am looking for some information and suggestions. What type of fitting is used between the pipes and the oil cooler (3/4 JIC?)?. Will a Kawasaki GT750 Cooler fit? Are there any other Bike oil coolers that can be made to fit?
____________________
Thanks

[Casper]

It also looks the same as the GPz ones. I would say as long as your not going to use a smaller one you should be fine. Try and get the part number from this site

https://www.cmsnl.com/

And look at the part number for the 750 and the gpz550/750 or the zephyr 550/750. You can look at the ZR7 but that may be slightly larger.

[Casper]

Just had a look at your location. You must be close to Braking point in Aberdeen. Im sure they will sort you out cheap.

https://www.breakingpoint.co.uk/

[EmacD]

Thanks for the reply. My experience with breaking point has not been good. I have had them do work on my bike in the past, and it has been less than sterling service! So out of principle I will not had any more money to them!

I have looked at the GPZ and the fitting looks similar, but on the GT750 it looks like the mounting holes are slightly different. the ZR7 would be a good one as well, but requires a bit of customisation to mount.

I have a cooler (in really good condition) from a Honda CB750 in good condition, but it uses Flange mounts rather than JIC type !
____________________
Thanks

[EmacD]

The GPZ and the GT have the same part number on the Dutch site, so that opens up my possibilities! (i.e. 39061)
____________________
Thanks