|
|
| Author |
Message |
| AcIdBuRnZ |
This post is not being displayed .
|
 AcIdBuRnZ World Chat Champion

Joined: 28 Jul 2003 Karma :   
|
|
| Back to top |
|
You must be logged in to rate posts |
|
 |
| hmmmnz |
This post is not being displayed .
|
 hmmmnz Super Spammer

Joined: 22 Aug 2006 Karma :   
|
|
| Back to top |
|
You must be logged in to rate posts |
|
 |
| Vincent |
This post is not being displayed because the poster is banned. Unhide this post / all posts.
|
 Vincent Banned

Joined: 16 Oct 2006 Karma :    
|
 Posted: 15:16 - 28 Apr 2014 Post subject: |
 |
|
|
|
| Back to top |
|
You must be logged in to rate posts |
|
 |
| Richy CB1000 |
This post is not being displayed .
|
 Richy CB1000 Trackday Trickster
Joined: 06 May 2012 Karma :  
|
|
| Back to top |
|
You must be logged in to rate posts |
|
 |
| AcIdBuRnZ |
This post is not being displayed .
|
 AcIdBuRnZ World Chat Champion

Joined: 28 Jul 2003 Karma :   
|
|
| Back to top |
|
You must be logged in to rate posts |
|
 |
| AcIdBuRnZ |
This post is not being displayed .
|
 AcIdBuRnZ World Chat Champion

Joined: 28 Jul 2003 Karma :   
|
|
| Back to top |
|
You must be logged in to rate posts |
|
 |
| Richy CB1000 |
This post is not being displayed .
|
 Richy CB1000 Trackday Trickster
Joined: 06 May 2012 Karma :  
|
 Posted: 20:59 - 28 Apr 2014 Post subject: |
 |
|
Compress the spring, there's the collet on the bottom (1) that will then be "loose" and able to slide out round the rod as it has an open end to it like a "C"
https://i.imgur.com/3gj9yZe.png
Just asking as if you're planning to get them re sealed/gassed etc.... could hold off powder coating etc... and just smarten them up.
Good old smoothrite for the spring and after rust proofing, actually chrome wrap the barrel of the body, did that to mine it's temporary fix thats lasted three years so far.
I'd like to know what you end up doing with the pre load ring. I have to regularly adjust from 2 to 5 when my lad wants a lift and even with a film of rubber inside the C spanner it still chips off! |
|
| Back to top |
|
You must be logged in to rate posts |
|
 |
Old Thread Alert!
The last post was made 12 years, 205 days ago. Instead of replying here, would creating a new thread be more useful? |
 |
|
|