gearbox bearing.

[pdk20030]

Does anyone have a rough price to replace a gearbox bearing on a yamaha fzr600r?

[Chuffin Nora]

Yes, roughly.

It'll cost the price of the bearing
the full gasket set
all relevant oil seals and o-rings
any fastener, washer or shim required as per the FULL WORKSHOP MANUAL's say-so
tube of silicone gasket
Stanley blade, Scotchbrite and a whiff of WD40 for old gasket removal
engine oil and filter
tea
bacci
no more than three brain cells
no more than twelve hours of your time
and
because, I presume, you've a human brain coupled to a pair of hands, each possessing four fingers and an opposable thumb
it won't cost you the best part of a monkey for someone else to do what is, essentially, child's play


Good luck!

[iooi]

[_Iain_]

Did you know there's four bearings on the shafts alone looking at the EPC, plus whatevers on the selector drum, plus whatevers on the clutch etc etc. They all have different prices & some can be replaced with wheel bearings and such to reduce costs. So depends if you're on about using genine parts, pattern parts, or whatever does the job cheapest.

As you've not mentioned which bearing, which year your bike is, or really any detail other than what I suspect to be a pub diagnosis of a few mates standing round the bike going "That theres a fucked gearbox bearing that is" whilst also completely failing to take into account all the bits that can go potato in the gearbox when a bearing collapses it's pretty hard to price anything up at all!

Are we talking engine in the frame, engine out of the frame, engine in bits already, supply just parts, parts and labour to repair & fit gearbox with unknown damaged components or what?

Moar detail required
____________________
Please be aware that the above post may be full of complete nonsense.
Riding: '07 KTM Duke II, Baotian BT49QT-20 Driving: '88 Volvo 340