honda cbr 125 swingarm bearings

[Jonny491]

Right guys, I was planning on getting my swingarm powder coated over the winter and I would obviously be replacing the bearings in them, however when I've rung up bike parts dealers including fowlers and they all say you can't buy just the bearings you have to buy a whole new swingarm.

So I was wondering doesn't anybody know any honda swingarm bearings would fit?

My bike is a 2006 cbr 125

Cheers
____________________
Honda cbr 125 2006- Sold, Current 2012 yamaha XJ6N

[smallfrowne]

Hmmmm interesting, there are no bearings listed.

Does this look like your swingarm?
https://www.lingshondaparts.com/hpl/images/13KPP4E1/imge/F__2200.jpg

Patch up with hammerite

Silly Honda
____________________
'90 VFR750; '89 NC30; '95 DR650; '89 CD250U; ~'82 CG125; ~C90

[Rogerborg]

[Mark65]

I stripped my CG Swingarm with a wire brush on a drill, used Jenolite on slight surface rust, then 2 coats of red oxide, 2 coats of stone chip and the 3-4 coats semi gloss Plasticote Enamel. two and a half years later 15k still rock solid till I sold it.

Mark
____________________
07 Yamaha YBR125, 07 Honda CG125 , 15 CBR300R (Chocolate Crank, Deaded), 16 CB500FA, 19 Honda Forza 300, 70 Suzuki SV650

[P.addy]

Again, wouldn't bother, sand and paint if you want it to look nice.