|
Author |
Message |
Easy-X |
This post is not being displayed .
|
Easy-X Super Spammer
Joined: 08 Mar 2019 Karma :
|
|
Back to top |
|
You must be logged in to rate posts |
|
|
thx1138 |
This post is not being displayed .
|
thx1138 World Chat Champion
Joined: 06 Oct 2005 Karma :
|
|
Back to top |
|
You must be logged in to rate posts |
|
|
G |
This post is not being displayed .
|
G The Voice of Reason
Joined: 02 Feb 2002 Karma :
|
|
Back to top |
|
You must be logged in to rate posts |
|
|
Easy-X |
This post is not being displayed .
|
Easy-X Super Spammer
Joined: 08 Mar 2019 Karma :
|
|
Back to top |
|
You must be logged in to rate posts |
|
|
Easy-X |
This post is not being displayed .
|
Easy-X Super Spammer
Joined: 08 Mar 2019 Karma :
|
|
Back to top |
|
You must be logged in to rate posts |
|
|
Easy-X |
This post is not being displayed .
|
Easy-X Super Spammer
Joined: 08 Mar 2019 Karma :
|
|
Back to top |
|
You must be logged in to rate posts |
|
|
G |
This post is not being displayed .
|
G The Voice of Reason
Joined: 02 Feb 2002 Karma :
|
|
Back to top |
|
You must be logged in to rate posts |
|
|
Easy-X |
This post is not being displayed .
|
Easy-X Super Spammer
Joined: 08 Mar 2019 Karma :
|
Posted: 14:48 - 29 May 2019 Post subject: |
|
|
Experiment 1: at what point will an off the shelf circuit (like an opto-isolated relay) activate from the low signal from the throttle? (Throttle position generates a voltage from 0v to 5v.) Hopefully lower than a typical LED trigger voltage of 1.2v otherwise the bottom 24% of the throttle is dead zone
Experiment 2: run a manual push button to the controller's ebrake input. Ease off the throttle and stab button. Use imagination to consider if this was the effect I was looking for.
Bonus news item: my boss is on holiday and he's left a stack of ebike connectors and wiring and things on his desk where he rigged up a relay switched 12v headlamp from his 6v Bafang lamp output ____________________ Husqvarna Vitpilen 401, Yamaha XSR700, Honda Rebel, Yamaha DT175, Suzuki SV650 (loan) Fazer 600, Keeway Superlight 125, 50cc turd scooter |
|
Back to top |
|
You must be logged in to rate posts |
|
|
G |
This post is not being displayed .
|
G The Voice of Reason
Joined: 02 Feb 2002 Karma :
|
|
Back to top |
|
You must be logged in to rate posts |
|
|
GettinBetter |
This post is not being displayed .
|
GettinBetter Crazy Courier
Joined: 20 Jun 2019 Karma :
|
|
Back to top |
|
You must be logged in to rate posts |
|
|
Easy-X |
This post is not being displayed .
|
Easy-X Super Spammer
Joined: 08 Mar 2019 Karma :
|
Posted: 17:33 - 20 Jun 2019 Post subject: |
|
|
Nobody with any sense connects lithium-ion batteries to anything directly
I have a 2-wire BMS (battery management system) which handles both charging and discharging, over & under voltage, etc.
As an aside you can also get 3 or 4-wire BMS boards where the charging and discharging circuit are separate which obviously would be no use in a regen scenario. ____________________ Husqvarna Vitpilen 401, Yamaha XSR700, Honda Rebel, Yamaha DT175, Suzuki SV650 (loan) Fazer 600, Keeway Superlight 125, 50cc turd scooter |
|
Back to top |
|
You must be logged in to rate posts |
|
|
Old Thread Alert!
The last post was made 4 years, 356 days ago. Instead of replying here, would creating a new thread be more useful? |
|
|
|