Nsr 125 starter motor bearing replacement plz help

[Rory123]

I recently rebuilt my starter to find that the bearing that attaches to the end of the motor part (that contacts the brushes) needs replacing. I could not find this bearing to purchase leading me to think I need a new starter if anyone has any ideas where I can source this bearing would be greatly appreciated.
____________________
womanizer

[stinkwheel]

Measure it up and plug the numbers into simplybearings.co.uk

Or see if it has a part number stamped/etched onto it.
____________________
“Rule one: Always stick around for one more drink. That's when things happen. That's when you find out everything you want to know.”
I did the 2010 Round Britain Rally on my 350 Bullet. 89 landmarks, 3 months, 9,500 miles.

[alains]

there is no bearing in this starter . they are auto lubricating bronze stuff
as the starter do not turn very fast bearings are not essential
some picts of different parts of it and i may help you
____________________
the worst day fishing is better than the best day working

[WD Forte]

They may not turn fast but there is significant lateral pressure applied
when it's working
and any well made starter motor should have a bearing or phosphor bronze (or what's known as 'Oilite') bush at the business end of that shaft.

The good news is, if it does have a bush instead of a bearing, simplybearings.co.uk will probably flog them as well
____________________
bikers smell of wee

[Minty]

If it is NSR related, listen to Alains. He is Mr NSR.
____________________
My fingers smell of your mum.

[Rory123]

I took the starter apart again to measure the bearing and the bearing had exploded, there were little balls everywhere. The magnets have also broken. Anyone know the best place to buy a starter? Cheers.
____________________
womanizer

[Ste]

Can you post some photos of the starter?