Aerox 50 (2006) Brake light HELP please!

pcnut · L Plate Warrior Joined: 17 Dec 2007 Karma :

Has anyone a wiring diagram as i have a problem with the brake light not working, bulb is fine and tail light is ok. I am guessing that it is using an earth switch via the break levers to activate the bulb.

Thanks PCNUT

Crying or Very sad

divuk83 · World Chat Champion Joined: 27 Nov 2003 Karma :

Brake light switch will have gone. Costs a couple of pounds from almost any garage and can be fitted in minutes.

Dave

J.K.R · World Chat Champion Joined: 06 Feb 2005 Karma :

As divuk says, Will be the little switch, Very bad for going if not lubed often Thumbs Up

____________________
www.oldskoolsuzuki.info

kat250 · World Chat Champion Joined: 22 Feb 2005 Karma :

Notorious for going on the aerox's if its 2006 it will still be under warranty go to a yamaha dealer and get it replaced under warranty.
____________________
in the famous word of jimmy pop "would you F*ck me for blow"
In the words of banditshigh "would you blow me to f*ck"

pcnut · L Plate Warrior Joined: 17 Dec 2007 Karma :

where is the switch located and Many thanks for all the replys.

Laughing

J.K.R · World Chat Champion Joined: 06 Feb 2005 Karma :

Look on the master cylinder, Where the lever attaches there will be a small round looking switch with 2 wires coming out, It unscrews.

As far as i remember you have to take the front handlebar cover off to get at them on aerox's Thumbs Up

____________________
www.oldskoolsuzuki.info

pcnut · L Plate Warrior Joined: 17 Dec 2007 Karma :

Thanks J.K.R

pcnut · L Plate Warrior Joined: 17 Dec 2007 Karma :

JKR: sorry for slow response, and short update to findings.

No master cylinder, but i found the problem with a DVM and it turned out to be the break lever's housing a switch that was no longer working this was controling the power to the break light and was about £6 per switch.