fitting hot-grips ?

[SVhovis650s]

as the wires from the grips to the control box are very long, i was looking for some advice.......last time i fitted them, i just cable tied it in a bunch (which looked crap)

the only other thing i can think of, is to cut the cables, but then i would need to use differant connecters.

any ideas
____________________
Oh, what sad times are these when passing ruffians can say Ni at will to old ladies. There is a pestilence upon this land, nothing is sacred. Even those who arrange and design shrubberies are under considerable economic stress in this period in history.

[hmmmnz]

cut them solder the joint and cover it in heat shrink.
if you can open the controller, then you could redo all your connections in there.
____________________
the humans are dead
I kick arse for the lord
Wiring Diagrams BIDNIP it bitches

[superslick]

either that or just solder them, put them in a connecting tube and crimp it. but heat shrink would probably be best as its the most waterproof.

If you have any problems getting heat shrinks send me a message and ill pocket afew from work and post them up
____________________
aprillia rs125 gp-1 2004

[SVhovis650s]

i dont think your meant to shorten the cables, as they are that lenth so they donk cook the grips.

so i was told?
____________________
Oh, what sad times are these when passing ruffians can say Ni at will to old ladies. There is a pestilence upon this land, nothing is sacred. Even those who arrange and design shrubberies are under considerable economic stress in this period in history.