cbr 600f problems

[Lyam]

today whilst riding the bike it was running out of power and cutting out when i applied the throttle at low revs, eg 2nd gear 3k apply throttle bike just starts slowing down and cuts out, if i pull the clutch in it cuts out immediately and i have to rev the shit out it before letting the clutch out almost as if it has an intermitent flat spot?

[Casper]

Look for air leaks round the carb rubbers, In and out side of the carbs. Have you had the carbs cleaned latley? Reason i ask is i had the same problem and it turned out to be my pilot jets, two vibrated loose and were sitting in the float bowls.

[dextersaurus]

As above, i had the same sort of problem when the jets were loose. i'd take the carbs off and have a look. not too difficult to take them off on the CBR anyway!

Cheers

[Casper]

[Lyam]

it does it intermitently now soetimes the bikes fine sometimes you go to pull away and unless the rpms at 6k it just stalls, ive no idea about jets etc i have a haynes manual will see f i can fix with the help of that