Throttle body moves.

[Srengam]

Hi all,

the whole enclose can move on the bars if I grab it and turn it.

If I'm correct (from what I searched and found), there are two screws and a peg to hold it in place.

The screws seem tight, but when I pull the throttle encolsure off the bars slightly I can see what does appear to be a broken peg in the bar itself.

I imagine that the peg is staying in forever.

But is there a chemical that sets sticky after a while or a safe fix? It only moves with quite a lot of force, not enough to stop me using it or anything. But if I can put some glue or something on the bars to make sure.

Or maybe some thin rubber strips or something?

Any ideas?
____________________
Suzuki GSX600F Katana (1997)

[iooi]

So you mean the throttle grip. The twisty bit you turn to make the bike go faster.

Just wrap some duck/gaffer tape round where the non moving part should be. That will allow some grip for it.

Just don't put it where you need it to twist....
____________________
Just because my bike was A DIVVY, does not mean i am......

[U_W v2.0]

nothing wrong with above suggestion, but if you fancy a cleaner way of doing it, as some people are picky over it, use rubber strips. much like what you get with a bicycle light or speedo.
____________________
BCF's biggest cunt list: Cansa, Pits, Rob