|
|
| Author |
Message |
| Loffty1 |
This post is not being displayed .
|
 Loffty1 Derestricted Danger
Joined: 31 Dec 2013 Karma :   
|
|
| Back to top |
|
You must be logged in to rate posts |
|
 |
| Blau Zedong |
This post is not being displayed because the poster is banned. Unhide this post / all posts.
|
 Blau Zedong Banned

Joined: 26 Jun 2006 Karma :     
|
|
| Back to top |
|
You must be logged in to rate posts |
|
 |
| Loffty1 |
This post is not being displayed .
|
 Loffty1 Derestricted Danger
Joined: 31 Dec 2013 Karma :   
|
|
| Back to top |
|
You must be logged in to rate posts |
|
 |
| bladerunner |
This post is not being displayed .
|
 bladerunner World Chat Champion
Joined: 09 Sep 2006 Karma :   
|
|
| Back to top |
|
You must be logged in to rate posts |
|
 |
| Loffty1 |
This post is not being displayed .
|
 Loffty1 Derestricted Danger
Joined: 31 Dec 2013 Karma :   
|
|
| Back to top |
|
You must be logged in to rate posts |
|
 |
| bladerunner |
This post is not being displayed .
|
 bladerunner World Chat Champion
Joined: 09 Sep 2006 Karma :   
|
|
| Back to top |
|
You must be logged in to rate posts |
|
 |
| Loffty1 |
This post is not being displayed .
|
 Loffty1 Derestricted Danger
Joined: 31 Dec 2013 Karma :   
|
|
| Back to top |
|
You must be logged in to rate posts |
|
 |
| Loffty1 |
This post is not being displayed .
|
 Loffty1 Derestricted Danger
Joined: 31 Dec 2013 Karma :   
|
|
| Back to top |
|
You must be logged in to rate posts |
|
 |
| bladerunner |
This post is not being displayed .
|
 bladerunner World Chat Champion
Joined: 09 Sep 2006 Karma :   
|
|
| Back to top |
|
You must be logged in to rate posts |
|
 |
| Teflon-Mike |
This post is not being displayed .
|
 Teflon-Mike tl;dr

Joined: 01 Jun 2010 Karma :    
|
 Posted: 16:51 - 01 Jan 2014 Post subject: |
 |
|
Have you replaced the condenser?
If not, do so.
Its an 'inert' component in the system; basically an electrolytic capacitor that's wires in parallel across the points, so that when the points open, the volts across the gap get 'soaked' into the capacitor, charging it up, rather than trying to 'arc' across the points gap.
When old, they break down, and can go closed circuit, effectively keeping the points 'closed' so no spark.
If you have replaced the points and or the condenser...
Go back and double triple check all the stoopid little terminal pillars, against the schematics in the book or on CMSL.
So many bits of the mechanically operated switch that is the points are 'live' carrying volts and easily earthed if a fibre washer is missing or a spade or ring connector made the wrong side of one!
Fif-faf-fiddly little fuggers, especially if you are working through a window in the bludy rotor... (on other engines) ____________________ My Webby'Tef's-tQ, loads of stuff about my bikes, my Land-Rovers, and the stuff I do with them!
Current Bikes:'Honda VF1000F' ;'CB750F2N' ;'CB125TD ( 6 3 of em!)'; 'Montesa Cota 248'. Learner FAQ's:= 'U want to Ride a Motorbike! Where Do U start?' |
|
| Back to top |
|
You must be logged in to rate posts |
|
 |
| WD Forte |
This post is not being displayed .
|
 WD Forte World Chat Champion

Joined: 17 Jun 2010 Karma :   
|
|
| Back to top |
|
You must be logged in to rate posts |
|
 |
| Loffty1 |
This post is not being displayed .
|
 Loffty1 Derestricted Danger
Joined: 31 Dec 2013 Karma :   
|
|
| Back to top |
|
You must be logged in to rate posts |
|
 |
| WD Forte |
This post is not being displayed .
|
 WD Forte World Chat Champion

Joined: 17 Jun 2010 Karma :   
|
|
| Back to top |
|
You must be logged in to rate posts |
|
 |
| Loffty1 |
This post is not being displayed .
|
 Loffty1 Derestricted Danger
Joined: 31 Dec 2013 Karma :   
|
 Posted: 19:59 - 02 Jan 2014 Post subject: |
 |
|
Done a test as the manual says. On the coil. Secondary test ohm meter to the 2 ht leads that's in spec with the manual. Primary test as it say in the manual ohm meter one to the blk/ white cable if the coil and the other to the ht lead. no reading at all. Nothing is this a fault with the coil. I'm guessing that cause there no reading it's duff. And hence no spark at the points. Am I on the right track or am I way off. Electrics isn't my best understanding.  |
|
| Back to top |
|
You must be logged in to rate posts |
|
 |
| Loffty1 |
This post is not being displayed .
|
 Loffty1 Derestricted Danger
Joined: 31 Dec 2013 Karma :   
|
|
| Back to top |
|
You must be logged in to rate posts |
|
 |
| Loffty1 |
This post is not being displayed .
|
 Loffty1 Derestricted Danger
Joined: 31 Dec 2013 Karma :   
|
|
| Back to top |
|
You must be logged in to rate posts |
|
 |
| bladerunner |
This post is not being displayed .
|
 bladerunner World Chat Champion
Joined: 09 Sep 2006 Karma :   
|
 Posted: 23:19 - 06 Jan 2014 Post subject: |
 |
|
Nice to hear you've got it fired up! Always a major milestone that! Mechanical advance unit and timing probs both worth checking as well as a bit of running just to let the motor settle again! Nice updates  ____________________ Current bikes...cbr929, KDX200's, Rd125lc mk2, RGV250's |
|
| Back to top |
|
You must be logged in to rate posts |
|
 |
Old Thread Alert!
The last post was made 12 years, 316 days ago. Instead of replying here, would creating a new thread be more useful? |
 |
|
|