|
|
| Author |
Message |
| 400bandit |
This post is not being displayed .
|
 400bandit World Chat Champion

Joined: 21 Dec 2005 Karma :  
|
|
| Back to top |
|
You must be logged in to rate posts |
|
 |
| doggone |
This post is not being displayed .
|
 doggone World Chat Champion

Joined: 20 May 2004 Karma :    
|
|
| Back to top |
|
You must be logged in to rate posts |
|
 |
| 400bandit |
This post is not being displayed .
|
 400bandit World Chat Champion

Joined: 21 Dec 2005 Karma :  
|
|
| Back to top |
|
You must be logged in to rate posts |
|
 |
| Al |
This post is not being displayed .
|
 Al World Chat Champion

Joined: 26 Feb 2006 Karma :   
|
 Posted: 18:30 - 21 Jan 2014 Post subject: |
 |
|
What your saying sounds fairly likely but you could check the pump is at fault by disconnecting where it is wired to the heating system and sticking a three pin plug on the end, try running the pump without the rest of the heating system on and see if it still trips.
There might be an easier way but with my limited electrical knowledge thats what I'd try  ____________________ Yamaha FZR400RR 3tj
My Instagram Thingy |
|
| Back to top |
|
You must be logged in to rate posts |
|
 |
| Moxey |
This post is not being displayed .
|
 Moxey World Chat Champion

Joined: 11 May 2011 Karma :   
|
 Posted: 10:28 - 22 Jan 2014 Post subject: |
 |
|
First turn the boiler off then look where the pump is housed (usually on the head of the unit) there should be 4 Allen head bolts, remove these and you can remove the pump, usually the impeller needs a bit of a clean and after 15 years I would expect it to.
If the pump itself is actually faulty then as Al suggested, but I would first try cleaning it  ____________________ Current: 02 FZS 1000 & 91 Royal Enfield Bullet 350 Some Bike Pics...
'I was too busy paying attention to pay attention' |
|
| Back to top |
|
You must be logged in to rate posts |
|
 |
| map |
This post is not being displayed .
|
 map Mr Calendar

Joined: 14 Jun 2004 Karma :     
|
 Posted: 11:01 - 22 Jan 2014 Post subject: |
 |
|
Don't know if this will help you but might be worth a try.
A few years ago my old pump failed after heating off most of the summer (I don't do that now).
Anyhow pump had a big screw in the middle that you could undo. Did this a a little water leaked out. Behind screw is another slot for a screwdriver. Turn this and it freed the pump. Put cap screw back on and all good (until it failed totally but I estimated it was nearly 20 years old as installed when house built). ____________________ ...and the whirlwind is in the thorn trees, it's hard for thee to kick against the pricks...
Gibbs, what did Duckie look like when he was younger?  |
|
| Back to top |
|
You must be logged in to rate posts |
|
 |
| kitty kat |
This post is not being displayed .
|
 kitty kat World Chat Champion

Joined: 20 Jun 2007 Karma :   
|
|
| Back to top |
|
You must be logged in to rate posts |
|
 |
| 400bandit |
This post is not being displayed .
|
 400bandit World Chat Champion

Joined: 21 Dec 2005 Karma :  
|
|
| Back to top |
|
You must be logged in to rate posts |
|
 |
| 400bandit |
This post is not being displayed .
|
 400bandit World Chat Champion

Joined: 21 Dec 2005 Karma :  
|
 Posted: 20:42 - 23 Jan 2014 Post subject: |
 |
|
New pump fitted and all is good again  ____________________ Current Bikes 650 Honda Bros, VTR1000 Firestorm // Past Bikes: Sachs Madass 50/110cc - Bandit 400 - FZR750
(+ a XS650 in lots of pieces in my garage and other places...) |
|
| Back to top |
|
You must be logged in to rate posts |
|
 |
| henry hoover |
This post is not being displayed .
|
 henry hoover Scooby Slapper
Joined: 15 May 2013 Karma :    
|
|
| Back to top |
|
You must be logged in to rate posts |
|
 |
Old Thread Alert!
The last post was made 12 years, 283 days ago. Instead of replying here, would creating a new thread be more useful? |
 |
|
|