CBR 929 electrical fault

leonsg · L Plate Warrior Joined: 18 Oct 2015 Karma :

Hi guys
I have a 2001 CBR 929 that refuses to start. Fuel pump primes, starter turns over and the HISS and key system is working. The engine has compression. What could be causing this?
Thanks in advance

Copycat73 · World Chat Champion Joined: 11 Jan 2013 Karma :

is this of any use Question

https://www.cbrxx.com/honda-cbr-xx-resource-center/10115-checking-for-fi-faults.html
____________________
Whatever I post I have no citation and no intention of providing one..
caveat emptor

kramdra · World Chat Champion Joined: 28 Oct 2010 Karma :

Check connection on bank angle sensor, which on CBR6 is located above the headlight. You can temporarily bypass it to test by unplugging connector. There should be 3 wires,

Yellow is switched 12v supply
Red is the angle sensor signal
Green is ground.

Bike will run when red and green are connected, engine will stop when red and yellow are connected. Use a bit of wire to bridge the red and green wires. However it should be enough to clean up corrosion on the pins and replug it.

leonsg · L Plate Warrior Joined: 18 Oct 2015 Karma :

Thanks copycat, actually very useful but unfortunately my error code light doesn't work so I'm not sure which error code its giving out. And okay thanks kramdra shall give that a try