Hanway Cafe 125 Issue

[peeky1323]

Hi All. My son has bought a 2020 Hanway BlackCafe 125 about 4 weeks ago. It's been fine for 2 weeks and then all of a sudden it's cutting out when you open the throttle more than 1/2 way. Also it idles rough. I unplugged what I thought was the MAF sensor and this made no different so I am thinking air leak although I can't see any issue on the throttle body, but I have not checked every vacuum hose etc. Sparkplug is fine. Does anyone have any ideas please?

[Nobby the Bastard]

Ask him what he's been fucking around with on it.
____________________
trevor saxe-coburg-gotha:"Remember this simple rule - scooters are for men who like to feel the breeze on their huge, flapping cunt lips."
Triumph Sprint ST 1050

[peeky1323]

[WD Forte]

If its EFI then it has an ECU which in turn will have DTCs so read em
____________________
bikers smell of wee

[Nobby the Bastard]

I'm still hedging my bets on the youngling had a fiddle and hasn't yet admitted it.
____________________
trevor saxe-coburg-gotha:"Remember this simple rule - scooters are for men who like to feel the breeze on their huge, flapping cunt lips."
Triumph Sprint ST 1050

[WD Forte]

Could well be, it looks like a cafe'd CG clone with EFI to comply with rules and yoofs is well into 'owner improvements'

Mind you, it is 2 years old now and chinese bikes haven't built a rep
for longevity
____________________
bikers smell of wee

[peeky1323]

[peeky1323]

[quote="WD Forte"]If its EFI then it has an ECU which in turn will have DTCs so read em[/quote

Yes, it's EFI. I am trying to find out what adapter I need for my ODB2 reader and also where the port is.

[WD Forte]

A lot of chinese bikes used the Delphi or Delphi cloned ECUs.
on some Delphi systems,
if you turned the ignition on then off then on again and wait
they would flash out the fault codes

worth a try
____________________
bikers smell of wee

[peeky1323]

[WD Forte]

I'm now under the impression they use a Mikuni (best known for carbs) ECU
and it uses a common KWP2000protocol at obd 1 level which should be enough to get DTCs from.

CMPO would probably flog you a 16pin OBD to 3 pin adapter
____________________
bikers smell of wee

[A100man]

[peeky1323]

[peeky1323]

[peeky1323]

Hi All.

Just an update in case anyone is interested. I replaced the coil and this resolved the issue. However, the engine management light is still on so I guess I need to get an ODB2/1 adapter cable to reset it.

[WD Forte]

The ECU may or may not be actually sensing the coil status so
the eml may be indicating something else.
Best to read and note codes, delete, ride bike for a short while and test again to see if any come back.
____________________
bikers smell of wee