|
|
| Author |
Message |
| SilvaRizla |
This post is not being displayed .
|
 SilvaRizla Spanner Monkey
Joined: 30 Apr 2006 Karma :     
|
|
| Back to top |
|
You must be logged in to rate posts |
|
 |
| veeeffarr |
This post is not being displayed .
|
 veeeffarr Super Spammer
Joined: 22 Jul 2004 Karma :     
|
 Posted: 20:35 - 06 Jun 2006 Post subject: |
 |
|
When/Where are you going to see it?
To check bent forks
1) Look at forks
2) Are they bent?
Check general condition of things like tyres, chain, etc, this will give you an idea of how well the bike's been looked after.
A well lubed, clean chain for example. |
|
| Back to top |
|
You must be logged in to rate posts |
|
 |
| SilvaRizla |
This post is not being displayed .
|
 SilvaRizla Spanner Monkey
Joined: 30 Apr 2006 Karma :     
|
|
| Back to top |
|
You must be logged in to rate posts |
|
 |
| veeeffarr |
This post is not being displayed .
|
 veeeffarr Super Spammer
Joined: 22 Jul 2004 Karma :     
|
 Posted: 23:03 - 06 Jun 2006 Post subject: |
 |
|
Nope  |
|
| Back to top |
|
You must be logged in to rate posts |
|
 |
| skchris2002 |
This post is not being displayed .
|
 skchris2002 Two Stroke Sniffer
Joined: 29 Apr 2006 Karma :   
|
|
| Back to top |
|
You must be logged in to rate posts |
|
 |
| sunbear |
This post is not being displayed .
|
 sunbear Could Be A Chat Bot
Joined: 12 Jul 2005 Karma :  
|
 Posted: 10:06 - 07 Jun 2006 Post subject: |
 |
|
I should imagine if it wasnt jetted properly the engine would be spluttering when revving  ____________________ Bikes had : BMW F650, suzuki tr50, gt125, SV400, GSXR600 SRAD. Honda CBR900RRP, CBR600FX, CBR1000F, VT600, Transalp 600, mtx125, nsr125r, CB500T, Yamaha fy50, tzr125, tdr125, XV535, Diversion 600, Fazer 600, TDM850 MK1 & MK2, Majesty 400, XV 1100. Cagiva mito evolution, Aprilia rs125, Piaggio x9 125. DNA 125 . Suzuki Bandit 600, GZ125 Marauder, RF600 , RF900RS2, Kawasaki ZZR400, ZX6R Ninja, ZZR600 . Ducati 750 Sport . Triumph Tiger 955i. CURRENT : 2004 Kawasaki Z750 and LOVIN IT ! |
|
| Back to top |
|
You must be logged in to rate posts |
|
 |
| edd |
This post is not being displayed .
|
 edd Nearly there...

Joined: 06 Jul 2005 Karma :   
|
 Posted: 17:38 - 08 Jun 2006 Post subject: |
 |
|
It wouldnt neccesarily be spluttering, but it could be jetted wrongly. All you can really do is ask the seller. Beyond that jets arent expensive, and all it will cost you is a bit of a pain setting it up. As for the bent forks, Toby is a bit inconclusive. Forks can be bent slightly and look ok on appaearance, its best to have a ride of the bike and make sure that it feels right. Other than that theres not loads you can do for this either, but again 2nd hand forks for a mito arent that pricey so worst case scenario for both these probalems isnt really too bad. ____________________ Bluespark Automotive - Diesel Tuning for Performance and Economy |
|
| Back to top |
|
You must be logged in to rate posts |
|
 |
| SteWhit |
This post is not being displayed .
|
 SteWhit Nova Slayer

Joined: 10 Jun 2005 Karma :     
|
 Posted: 12:46 - 09 Jun 2006 Post subject: |
 |
|
Derestricted Jest sizes for the Mito are 120 65 65, 120 being the main jet. You can also tell if it has been done by looking at the air box snorkel on top of the box, if it has small round inlets on the snorkel then it's standard, if they are large square ones then it's been derestricted with a proper cagiva kit. If you just lift the tank you should be able to see the air box without having to remove the seat.
Also if the bike has the standard exhaust on, check if the extra chamber on the left hand side (where it joins the head) has been removed, if it has then it's full power.
 ____________________ Are You Serious?? |
|
| Back to top |
|
You must be logged in to rate posts |
|
 |
| SilvaRizla |
This post is not being displayed .
|
 SilvaRizla Spanner Monkey
Joined: 30 Apr 2006 Karma :     
|
|
| Back to top |
|
You must be logged in to rate posts |
|
 |
Old Thread Alert!
The last post was made 20 years, 111 days ago. Instead of replying here, would creating a new thread be more useful? |
 |
|
|